REMdevice BRICK 09K - CHANGE OF FREQUENCY ON THE TRANSMITTER

Installation, start up and operating manual – version 5.3 Gen.10
Radio control BRICK and PAIL
CHANGE OF FREQUENCY on the transmitter
Switch off the transmitter unit and remove the screws. Remove lower
cover slowly making sure not to pull out the connection wire between the
electronic cards.
Using a pointed tool move one or more of the microswitches (CHANGE
FREQUENCY) into a new configuration using the table of channels in
FREQUENCY CHANGE
FUNCTION CHANGE
SERIAL NUMBER
Figure 12
FREQUENCY
CHANGE
FUNCTION CHANGE
SERIAL NUMBER
BRICK
PAIL
22 REMdevice
®
- ITALY