Installation, start up and operating manual – version 5.3 Gen.10
Radio control BRICK and PAIL
Instructions for transferring control of the
lifting machine from one transmitter unit to
the other
There are two different ways to carry out transfer of control.
1) Turn off the lifting machine (thereby cutting power to the
receiver unit RxDIN).
Switch on the lifting machine that supplies power to the receiver
unit (RxDIN).
2) Activate the RELEASE command (described below).
Then switch on the other transmitter unit supplied and press the START
for 10 seconds.
Once the receiver unit has recognised the transmitter unit the machine
will emit:
• ONE acoustic signal (primary transmitter)
• THREE acoustic signals (auxiliary transmitter recognised by the
identification label).
From this moment on unless the power supply is turned off at the
receiver unit (RxDIN) or until the RELEASE command is activated, the
operating machine can be controlled only by this transmitter unit.
RELEASE command
The RELEASE command can only be carried out by the transmitter unit
currently in control of the machine.
Procedure:
a) turn and disengage the STOP button and turn the key to ON (if
present in model in use).
b) BRICK: press the following pushbuttons at the same time; PR15,
PR21, PR22 and the START pushbutton and then release.
PAIL: Move the joysticks to command PR15 and PR19 and START
at the same time and then release.
Following this operation the machine will emit two acoustic signals and
will subsequently be controlled by the first transmitter unit to activate
START command.
REMdevice
®
- ITALY
31
To Next Page
Loading...