Installation, start up and operating manual – version 5.3 Gen.10
Radio control BRICK and PAIL
Charging the batteries
The radio control unit’s batteries are inside the transmitter equipment
and are charged using a unique method based on electromagnetic
induction without the need for metal electrical contacts or connection
cables. When the batteries are at a low level there is a warning signal of
three short tones and the red led flashes.
After the first warning signal, the radio control unit will operate perfectly
for up to further 60 minutes.
WARNING !
The battery charger supplied with the system must be kept
in a safe dry place, out of direct sunlight and protected from
the rain. It must be connected to the electrical mains so
that the plug is always accessible.
REMdevice
®
- ITALY
7
To Next Page
Loading...
