n Control in REMKO networks with five-stage fan
control and single control on specific slave
units
Master Slave Slave
1 1 1
Master Slave 1 Slave 2
1: Addressing
Manual mode
The unit can also be started manually. Press the
RESET key on the receiver unit of the cover to
activate automatic mode.
In manual mode, the following settings apply:
Cooling mode: 24°C, fan speed: AUT
O
Heating mode: 26 °C, fan speed: AUTO
Press a key on the infrared remote control to inter-
rupt manual mode.
Display
The illuminated display LEDs indicate the set fan
speed:
LED "H" (red) = high fan speed
LED "M" (yellow) = medium fan speed
LED "L" (green) = low fan speed
Fig. 4: Display on the unit
1: "RESET" key/Manual operation
If the LEDs, flash, a malfunction has occurred
on the indoor unit. (See "T
roubleshooting and
customer service" chapter )
Operation with IR remote control that is fitted
as standard
The unit is easily operated using the standard
infrared remote control. The indoor unit beeps to
acknowledge the correct transmission of data.
If it is not possible to program the indoor unit with
the remote control, then it can also be manually
operated.
The infrared remote control sends the programmed
settings a distance of up to 6 m to the receiver of
the unit.
Data will only be received correctly if the remote
control is pointed at the receiver and no objects
are obstructing the transmission path.
First insert the supplied batteries (2 each, type
AAA) into the remote control. T
o do so, pull off the
flap of the battery compartment and insert the bat-
teries correctly by polarisation (see marks).
NOTICE!
Immediately replace flat batteries with a new
set, otherwise there is a risk of leakage. It is
recommended that the batteries are removed if
the equipment is shut down for longer periods.
Fig. 5: Maximum distance
19
To Next Page
Loading...
Need help?
General
