REMKO WLT EC Series User Manual

Keys on the remote control
2
14
4
1
7
5
13
6
3
12
11
8
9
10
Fig. 6: Keys on the remote control
1
"POWER" key
Press this key to operate the unit.
2
"TEMP" key
Press this key to set the desired temperature in
1 °C steps within the range 16 °C to 30 °C.
3
"SLEEP" key
Pressing this key will automatically increase or
decrease the target temperature by 1 °C within an
hour in cooling mode and heating mode respec-
tively.
4
"MODE" key
Press this key to select the operating mode. The
indoor unit has 5 modes:
1. Automatic mode (COOL/HEA
T):
In automatic mode, the temperature is maintained
at the constant setpoint.
2. Cooling mode (COOL):
In cooling mode, the warm room air is cooled to
the lower pre-set target temperature.
3. Dehumidification mode (DRY):
In this mode, the room is mainly dehumidified.
4. Recirculation mode (FAN):
In recirculation mode only the air is circulated. The
room temperature is not controlled.
5. Heating mode (HEAT):
In heating mode, the cold room air is heated to the
pre-set higher temperature.
5
"SWING" key
This key switches on the oscillating fins to provide
improved air distribution in the room. It can also be
used to lock the fins.
6
"F
AN" key
Press this key to set the desired fan speed. 4
speeds are available: Automatic, high, medium
and low fan stage.
7
"TIME-ON" key
This key is used to program the automatic switch-
on function for the indoor unit.
8
"NETWORK" key
Use this key to transfer the data that was set to all
other units within a network.
9
"SILENT" key
Press this key to set a particularly low fan speed.
10
"TIME-OFF" key
This key is used to program the automatic switch-
of
f function for the indoor unit.
REMKO WLT EC series
20

REMKO WLT EC Series Specifications

General

Brand	REMKO
Model	WLT EC Series
Category	Air Conditioner
Language	English