07
Ethernet Connection
Place or fix the Access Station Nano at the desired location.
Make sure you leave enough space to access the ports
and you can see the side to check the LED display.
Step 1 Installation Location
Step 2 Connect the Station to the Internet
In case of using Ethernet connect the Ethernet
cable to the station’s Ethernet WAN port.
1)
Connect the other end of the Ethernet cable to the
Ethernet wall socket or router.
2)
Powering the Station
Connect the USB C Power port to the power adapter
and plug the adapter to a power outlet.
1)
Station will boot up automatically.3)
To reboot the station, press the Reset button and
it will automatically reboot.
4)
Insert the electric wire into the power cord separation
prevention groove to prevent the power cord from
being easily disconnected from the USB port during use.
2)
For NAP-3 / NAP-7
To Next Page
Loading...