ENGINE AND PERIPHERALS
Overhauling the engine
10
10-50
Remove the camshaft lateral shim
(pulley end).
Undo the rocker arm adjusting
bolts.
Remove the rocker arm rail.
Remove the cylinder head bolts
and fastening nuts.
Insert a wooden shim and strike
the side of the cylinder head to
unstick it from the sealing face
within the clearance limit
between the cylinder head and
the studs. As the cylinder head
gasket is cemented to the cylinder
block, the cylinder head and the
cylinder liners, it is very important
not to raise the cylinder head,
which would unstick the cylinder
liners from their base and allow dirt
to penetrate.
Remove the cylinder head.
To Next Page
Loading...
