NU739_4_G2-FRA.qxd 2/02/06 16:45 Page 2.36
NU739-4 - B73
C:\Documentum\Checkout\NU739_4_T2-ENG.win 17/3/2006 11:35
-page36
2.36
PARKING PROXIMITY SENSOR
Operating principle
Ultrasonic detectors, installed in
the front or rear bumper depending
on the vehicle, measure the distance
between the vehicle and an obstacle
whilst reversing.
When reverse gear is selected a beep
sounds.
This measurement is indicated by
beeps which become more frequent
the closer you are to the obstacle,
until they become one continuous
beep when the obstacle is
approximately 25 centimetres from
the vehicle.
Thesoundofthebeepsfromtherear
system differs to that of the front
system.
Note: make sure that the ultrasonic
sensors are not blocked (dirt, mud,
snow, etc.).
Operating faults
When the system detects an
operation fault there will be a
5-second continuous beep as a
warning when reverse gear is
selected. This beep is accompanied
by the Check Parking Proximity
Sensor message. Contact your
RENAULT Dealer.
This function is an
additional aid that
indicates the distance
between the vehicle and an
obstacle, using sound signals.
It cannot, therefore, under any
circumstances replace the
vigilance or the responsibility of
the driver.
The driver should always pay
attention to sudden incidents
during driving: always ensure that
there are no moving obstacles
(such as a child, animal, pram or
bicycle, etc.) or small, narrow
objectssuchasstonesorpostsin
your path when manoeuvring or
nearing an obstacle.
To Next Page
Loading...
