NU739_4_G2-FRA.qxd 2/02/06 16:45 Page 2.38
NU739-4 - B73
C:\Documentum\Checkout\NU739_4_T2-ENG.win 17/3/2006 11:35
-page38
2.38
PARKING PROXIMITY SENSOR (continued)
Vehicle fitted with front and
rear parking proximity sensor
Operation
As long as the vehicle is being
driven at a speed below 7 mph
(12 km/h) or thereabouts, the
parking proximity sensor system
remains on.
Any object located less than
approximately 60 centimetres away
from the front of the vehicle is
detected and a beep sound is
emitted.
Whenreversegearisselected,the
system switches automatically to
manoeuvre mode.
Any object located less than
approximately 1 metre away from
the front and/or less than 1.50
metres from the rear of the vehicle is
detected and a beep sound is
emitted.
If there are obstacles located close to
both the front and rear of the
vehicle, only the closest of the two
will be acknowledged and the
corresponding front or rear beep
sound will be emitted.
If obstacles are detected both to the
front and to the rear of the vehicle at
thesametime,andtheyareboth
within 30 centimetres from the
vehicle, the corresponding front
and rear beeps will be emitted
alternately.
Manual activation/deactivation
of the front and rear parking
proximity sensor
Press switch 1 quickly to deactivate
the system.
The warning light in the switch
comes on to remind you that the
system has been deactivated; the
Parking Proximity Sensor
Deactivated message appears on the
instrument panel for around
10 seconds.
You can reactivate the system by
pressing the switch again: the
warning light will go out and
Parking Proximity Sensor Activated
message will be displayed on the
instrument panel for approximately
10 seconds.
The system will reactivate
automatically each time the engine
is switched off.
When the vehicle is being driven
at a speed below 7 mph
(12 km/h), certain noises (motor
cycle, lorry, pneumatic drill,
etc.) may trigger the beeping
sound.
To Next Page
Loading...
