Renesas RA Family EK-RA4E2 – Quick Start Guide
R20QS0037EG0200 Rev.2.00 Page 13 of 26
Feb.21.23
Figure 9. Next Steps
11. Press space to return to the ‘welcome and main menu’ screen.
5. Customizing the Quick Start Example Project
This section lists the requirements and instructions for customizing the Quick Start example project.
Hardware Requirements
• EK-RA4E2 board
• Micro USB device cable
• A PC with at least one USB port
Software Requirements
• Windows
®
10 operating system
• e
2
studio IDE
• SEGGER J-Link
®
USB drivers
• FSP
• Quick Start example project
5.1 Downloading and Installing Software and Development Tools
Before the Quick Start example project can be modified, it is necessary to download and install software and
development tools on the host PC.
The FSP, J-Link USB drivers, and e
2
studio are bundled in a downloadable platform installer available on the
FSP webpage at renesas.com/ra/fsp.
New users are recommended to use the Quick Install option provided
in the installation wizard, to minimize the amount of manual configuration needed.
There is no need to download and install software, development tools, and drivers separately.
To Next Page
Loading...
