Renesas EK-RA4E2 - Modifying, Generating, and Building the Quick Start Example Project; Figure 17. Opening the Configurator; Figure 18. Open Perspective

Renesas RA Family EK-RA4E2 – Quick Start Guide
R20QS0037EG0200 Rev.2.00 Page 19 of 26
Feb.21.23
5.3 Modifying, Generating, and Building the Quick Start Example Project
This section provides instructions to modify the Quick Start example project. The Quick Start example project
can be modified by editing the source code and reconfiguring the properties of the MCU peripherals, pins,
clocks, interrupts, and so forth.
Note: The specific modifications that can be performed to the Quick Start example project are not
prescribed in this QSG.
1. Once the Quick Start example project is imported, click the configuration.xml file to open the
configurator. The configurator provides an easy-to-use interface to configure the properties of the MCU
peripherals.
Figure 17. Opening the Configurator
2. For example, in the Stacks tab of the configurator, the user can click to select modules to modify the
configuration settings, as required, in the Properties tab. The following screen shot illustrates modifying
the ADC driver configuration.
Note: To access the stack component properties, the view must be set to FSP Configuration using the
Open Perspective button, if necessary.
Figure 18. Open Perspective