Renesas RA Series Quick Start Guide

Renesas RA Family EK-RA2E1 – Quick Start Guide
R11QS0035EG0100 Rev.1.00 Page 7 of 26
Jan.04.21
1. Introduction
This Quick Start Guide (QSG) provides:
• An overview of the Quick Start example project that the EK-RA2E1 board comes pre-programmed with.
• Instructions for running the Quick Start example project.
• Instructions for importing, modifying, and building the Quick Start example project using Flexible
Software Package (FSP) and e
2
studio Integrated Development Environment (IDE).
1.1 Assumptions and Advisory Notes
1. Tool experience: It is assumed that the user has prior experience working with IDEs such as
e
2
studio and terminal emulation programs. The examples in this guide will use SEGGER RTT.
2. Subject knowledge: It is assumed that the user has basic knowledge about microcontrollers,
embedded systems, and FSP to modify the example project described in this document.
3. Prior to running the Quick Start example project or programming the EK-RA2E1 board, default
jumper settings must be used. Refer to the EK-RA2E1 user’s manual for the default jumper settings.
4. The screen shots provided throughout this document are for reference. The actual screen content
may differ depending on the version of software and development tools used.
2. Kit Contents
The following components are included in the kit:
1. EK-RA2E1 board
2. Micro USB device cable (type-A male to micro-B male)
Figure 1. EK-RA2E1 Kit Contents

Renesas RA Series Specifications

General

Brand	Renesas
Model	RA Series
Category	Microcontrollers
Language	English