- 9 -
EN
A.3 Ambient Conditions
(in accordance with DIN EN 61010-1)
Indoors;
up to an altitude of 2,000 m [6,500 ft] above sea level,
at a maximum relative humidity of 80% at 31ºC [87.8ºF], linear reduction up to 50% relative humidity at 40ºC [104ºF]
*)
under overvoltage category II conditions.
under level 2 contamination conditions;
B. Hazards and warnings
= Granted protection is not given any longer in case the unit is not operated according to the instruction manu-
al on hand.
= $$$%$%%$"%$"%$
required should only be carried out by an electrician.
= The unit should only be operated if the data on the rating plate corresponds with the data of regional mains
voltage.
= The unit should only be plugged into earthed sockets.
= The mains socket should be easily accessible.
= Check the connection lines (such as the mains cable), tubes and housing (such as the operating screen) on a
regular basis for damage (such as bends, cracks, porosity) or aging. Devices with damaged connection lines,
tubes or housing parts or other defects must no longer be used!
= Remove the plug and ensure the device is not switched back on!
= The unit should always be operated under supervision.
= Risk of injury!
Risk of injury if the components used are not approved. Always use original Renfert components.
= Please observe all applicable accident prevention regulations together with the following safety notes when
trimming:
= Always keep long hair, loose or wide sleeves or other clothing away from the trimmer. Hair or clothing can be
pulled into and wrapped up on the grinding wheel, resulting in injury!
= Never open the front cover while the motor is running. The restart protection will not stop the grinding wheel.
= Only open the front cover after the grinding wheel has come to a complete stop.
= Always wear protective eyewear when grinding.
= Do not reach into the grinding wheel while it is turning.
= *?$$%?@%$%?J#K"%$
the trimmer, resulting in serious injury.
= Trimmer table may only be lifted off when disc is at a standstill.
C. Approved personnel
The appliance may only be operated and serviced by trained personnel.
D. Prior to installation
Compare the data on the rating plate with the data of the regional mains voltage before installation.
The unit should only be plugged into earthed sockets.
We recommend connecting the device to a FI circuit breaker safety socket!
For the disposal of the grinding water install a separator system.
E. Repair
by an electrician.
Switch off and unplug the appliance before carrying out repairs and servicing work on electrical components.
EN
To Next Page
Loading...