1-5
www.renishaw.com/primo
GoProbe provides:
• An easy and intuitive way to get started with setting cycles.
• A simple and consistent ‘ve step’ method of operation.
• A choice of manual (jog) mode or automated mode.
• A solution that is compatible with a range of Renishaw probes as well as the Primo system.
GoProbe training kit
To ensure the maximum benet from the Primo system, Renishaw provides each Primo customer with a
GoProbe training kit: the training kit helps new users to get up and running with their new probing system
quickly and easily.
The training kit centres on the GoProbe training part, which has been designed to incorporate the most
common features encountered during automated setting and manufacturing. The GoProbe training part is
used to demonstrate all the probing cycles and is used in the e-learning practical exercises.
The GoProbe e-learning course is a PC-based course that will guide both new and experienced users
through the basics of probing using a combination of intuitive tutorials, interactive quizzes and practical
exercises.
By completing this training the user will be able to check that the Primo system is ready for use, and will be
able to use part setting, tool setting and probe set‑up cycles with condence.
Other learning aids included in the training kit are the pocket guide and quick-reference tool, for
convenient continual use at the machine. A GoProbe smartphone app is also available – see
www.renishaw.com/goprobe for details.
Each Primo system should be supplied with a training kit from your machine tool supplier. If you have not
received the training kit or if any elements are missing, contact your local Renishaw ofce, which can be
found by visiting www.renishaw.com/contact.
To Next Page
Loading...
Need help?
General
