1-2
Primo™ system: Before you begin
Microchip software licensing agreement
This product’s rmware has been developed by Renishaw with the use of the Microchip libraries, under the
following licensing terms:
This software is developed by Microchip Technology Inc. and its subsidiaries (“Microchip”). Redistribution
and use in source and binary forms, with or without modication, are permitted provided that the following
conditions are met:
1. Redistributions of source code must retain the above copyright notice, this list of conditions and the
following disclaimer.
2. Redistributions in binary form must reproduce the above copyright notice, this list of conditions and
the following disclaimer in the documentation and/or other materials provided with the distribution.
3. Microchip’s name may not be used to endorse or promote products derived from this software without
specic prior written permission.
THIS SOFTWARE IS PROVIDED BY MICROCHIP “AS IS” AND ANY EXPRESS OR IMPLIED
WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL
MICROCHIP BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR
CONSEQUENTIAL DAMAGES (INCLUDING BUT NOT LIMITED TO PROCUREMENT OF SUBSTITUTE
GOODS OR SERVICES; LOSS OF USE, DATA OR PROFITS; OR BUSINESS INTERRUPTION)
HOWSOEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT
LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF
THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
(c) Copyright 1999-2013 Microchip Technology, All rights reserved
Intended use
The Primo system is a combined pay-as-you-go spindle probe, tool setter and radio transmission interface.
The system enables automated workpiece inspection, job set-up, broken tool detection, rapid tool
measurement on multi-tasking machines and machining centres and transmits the outputs to the CNC
machine controller.
To Next Page
Loading...
Need help?
General
