Renogy MT-1 User Manual

3
Important Safety Instructions
Please save these instructions.
This manual contains important safety, installation, and operating instructions for the charge
controller. The following symbols are used throughout the manual to indicate potentially
dangerous conditions or important safety information.
WARNING: Indicates a potentially dangerous condition. Use extreme caution when
performing this task.
CAUTION: Indicates a critical procedure for safe and proper operation of the controller
NOTE: Indicates a procedure or function that is important to the safe and proper
operation of the controller.
General Safety Information
 Read all instructions, cautions, and notes in the manual before starting the installation.
 There are no serviceable parts inside the MT-1. Do not disassemble or attempt to repair the
meter electronics
 Do not allow water to enter the MT-1.
General Information
The Renogy MT-1 Tracer meter is the remote digital display used for the 10Amp or 20Amp Duo
Battery Charge Controllers. It is a self-diagnostics meter ideal for monitoring and displaying the
current solar system status information and any error indications the system might be
experiencing. The information is displayed on a backlit LCD display and is easily navigated
using the large buttons on the meter. The MT-1 Tracer meter could also be flush mounted on a
wall or flat surface using the mounting frame provided. The MT-1 Tracer is supplied with a 10
meter long cable and is connected using the RJ45 port.
Key Features
 Displays both solar voltage and battery voltage
 Displays charging current and load current
 Displays Amp-Hour and Watt-Hour accumulation
 2 different brightness levels for the LCD display
Included Components
 Wall Mounting Frame
 10 meter cable
Components NOT included
 Screws  ø 4mm (0.16in)

Renogy MT-1 Specifications

General

Brand	Renogy
Model	MT-1
Category	Measuring Instruments
Language	English