Renogy WANDERER User Manual

01
General Safety Information
Charge Controller Safety
This manual contains important safety, installation, and
operating instructions for the charge controller. The following
symbols are used throughout the manual:
There are no serviceable parts for this controller. Do NOT
disassemble or attempt to repair the controller.
Make sure all connections going into and from the controller
are tight. There may be sparks when making connections,
therefore, make sure there are not flammable materials or
gases near installation.
NEVER connect the solar panel array to the controller
without a battery. Battery must be connected first. This may
cause a dangerous occurrence where the controller would
experience a high open circuit voltage at the terminals.
Ensure input voltage does not exceed 50 VDC to prevent
permanent damage. Use the Open Circuit (Voc) to make
sure the voltage does not exceed this value when connecting
panels together in series.
Read all of the instructions and cautions in the manual before
beginning the installation.
Important Safety Instructions
Please save these instructions.
Indicates a potentially dangerous condition. Use
extreme caution when performing this task.
Indicates a critical procedure for safe and proper
operation of the controller
Indicates a procedure or function that is important
to the safe and proper operation of the controller.
NOTE
CAUTION
WARNING

Renogy WANDERER Specifications

General

Model	WANDERER
Max Input Power	130W (12V system, 10A) / 260W (12V system, 20A) / 390W (12V system, 30A)
Waterproof Level	IP32
Type	PWM
Rated Charge Current	10A / 20A / 30A
System Voltage	12V
Max PV Input Voltage	25V
Temperature Compensation	-3mV/°C/2V (Default)
Operating Temperature	-35°C to +55°C
Max Input Voltage	25V
Max Solar Input Current	10A / 20A / 30A
Max Load Current	10A / 20A / 30A
Protection	Overcharge Protection, Over-discharge Protection, Overload Protection, Short-circuit Protection, Reverse Polarity Protection