24 25
Using the Mode button
The Mode button (see page 9) is utilized to view current mode,
switch between different input modes and check the battery sta-
tus of the Multi Mic.
Current mode:
To view the current mode of operation, press the Mode button
once. The corresponding mode LED on the backside of the Multi
Mic will light up for 3 seconds.
Changing mode:
To change the mode of operation, do the following:
1. Press the Mode button once. The Mode LED corresponding
to the current mode will be lit.
2. Within 3 seconds, press the Mode button again to change
mode.
3. Repeat step 2 until the desired mode is obtained.
Checking the battery status
To view the current battery status press and hold the Mode but-
ton for at least 3 seconds until one or more of the Mode LEDs
starts to blink.
- 75 – 100 % remaining battery capacity: All Mode LEDs blink
- 50 – 75 % remaining battery capacity: Three Mode LEDs
blink (FM + Line-in + TC)
- 25 – 50 % remaining battery capacity: Two Mode LEDs blink
(FM + Line-in)
- <25 % remaining battery capacity: One Mode LED blinks
(FM)
i
Note: When less than 30 minutes of operating time is left
(low battery condition) the status LED will start blinking orange
(see Light Indicator chapter).
To Next Page
Loading...
