Why is there excessive condensation in the Respironics System One Heated Humidifier Medical Equipment tubing?
If you notice excessive condensation in the tubing of your Respironics Medical Equipment humidifier, it could be due to a heater plate temperature setting that is too high. Try reducing the heater control setting. Also, ensure that the humidifier and therapy device are positioned away from any air conditioning equipment.
How to reattach the humidifier door on Respironics System One Heated Humidifier Medical Equipment?
If the humidifier door of your Respironics Medical Equipment has been accidentally removed, it’s likely because it was lifted past the locked open position. To reattach it, remove the water tank, align the hinge side of the door with the back of the humidifier in a fully open position, ensuring the hinges align with the grooves of the humidifier. Rotate the door closed, applying pressure until it snaps past the locked open position. Then, verify that the door is working properly. If you need more help, contact your home care provider.
What to do if Respironics System One Heated Humidifier humidifier falls off?
If your Respironics Medical Equipment humidifier has fallen off your table or night stand, it could be because it wasn't properly seated or the tubing placement caused it to fall. Always place your humidifier on a hard, flat surface ensuring the rubber feet adhere to the surface and that the humidifier is level. Position it away from the edge of the surface to prevent accidental falls. If the humidifier falls and water enters the therapy device, drain all water and allow it to air dry completely before reapplying power. Ensure proper hose management by routing the tubing behind the bed's headboard. If the humidifier doesn't operate correctly after falling, contact your home care provider or Respironics.
What to do if Respironics System One Heated Humidifier humidifier doesn't turn on?
If nothing happens when you apply power to your Respironics Medical Equipment humidifier, it could be due to a loss of AC/DC power or the device being unplugged. Verify that the humidifier and therapy device are properly plugged in, ensuring the AC power cord is correctly connected to the power supply and the power supply cord is correctly plugged into the wall. If the problem continues, contact your home care provider and return the humidifier, therapy device, and power supply to determine if the issue lies with the therapy device, humidifier, or power supply.
What to do if Respironics System One Heated Humidifier Medical Equipment humidifier is cracked?
If your Respironics Medical Equipment humidifier is cracked or damaged, it is likely due to being dropped or mishandled. If the humidifier does not operate properly after such an incident, contact your home care provider or Respironics.
What if the water tank seal is damaged on Respironics System One Heated Humidifier?
If you notice the water tank’s middle seal is damaged on your Respironics Medical Equipment, it may have occurred during use. Check the seal for any tears or other damage. If it is damaged, contact your home care provider.
What to do if Respironics System One Heated Humidifier Medical Equipment shows a 'High Leak'?
If you are experiencing a 'High Leak' with your Respironics Medical Equipment, start by checking the tubing and mask for any kinks or tears. If damaged, contact your home care provider or Respironics for replacements. If the tubing is intact, reattach it, turn on the airflow, and ensure no air escapes from the port area. Another cause might be that the therapy device is not correctly seated against the humidifier. Remove and reconnect it, ensuring the air inlet port on the humidifier connects securely to the air outlet port on the device. A misaligned or damaged seal may also be the issue, in which case you should contact your home care provider or Respironics. Lastly, check that the humidifier tank is properly seated in the humidifier. Remove the water tank and slide it back in, ensuring ...
Why is the humidifier LED icon flashing on Respironics System One Heated Humidifier?
If the humidifier LED icon on your Respironics Medical Equipment therapy device is flashing, it indicates a communication issue between the therapy device and the humidifier. First, check the outlet power and ensure both the humidifier and therapy device are properly plugged in, with the AC power cord correctly connected to the therapy device's power supply and the wall. If the problem persists, contact your home care provider and return the humidifier, therapy device, and power supply to them to determine the source of the problem. It could also be due to the therapy device not being seated properly against the humidifier; in this case, remove and reconnect it, ensuring the air inlet port on the side of the humidifier connects securely to the air outlet port on the side of the device. Ano...
Details device emissions compliance with standards and guidance for its electromagnetic environment.
Details device immunity to electromagnetic disturbances and guidance for its environment.
General| Brand | Respironics |
|---|---|
| Model | System One Heated Humidifier |
| Category | Medical Equipment |
| Compatible Devices | Respironics System One CPAP and BiPAP machines |
| Humidification Type | Heated |
| Water Chamber Capacity | 325 ml |
| Heating Plate Material | Aluminum |
| Heated Tube Compatibility | Yes |
| Power Supply | Integrated |
| Heating Control | Automatic |
| Humidity Settings | 0 to 5 (Off, 1-5) |
To Next Page