21
USER MANUAL CUTTER Q1
RESQTEC Manual Q1 CUTTER (DM068K06)
6.
Check coupler functioning after cleaning.
Place
the
dust
caps
when
nished.
• Connect and disconnect the coupler at
least 3 times.
If the coupler is not functioning
properly, contact your Resqtec
distributor/supplier.
7.
After heavy use, CRC SP 400 can be used
to ensure the blades are protected against
corrosion.
• Only apply on the blades and protection
plates.
• Spray and clean with dry paper cloth.
• Clean any other parts that may have
attracted some coating in the process.
Read instructions carefully before
using CRC SP 400.
ATTENTION! IF YOU DECIDE THE BLADES AND PROTECTION PLATES NEED TO BE COATED FOR ANTI-CORROSION
PURPOSES, ONLY USE CRC SP 400. OTHER PRODUCTS ARE KNOWN TO HAVE NEGATIVE EFFECTS ON THE LUBRICANT
USED IN YOUR EQUIPMENT. OTHER PRODUCTS ALSO DO NOT HAVE THE HIGH PROTECTION GRADE THAT CRC SP 400
PROVIDES.
To Next Page
Loading...