Having inserted your disk, decide what to do next on your C64 or VIC 20, e.g.
browse the content, load a program and so on.
BROWSING A VIRTUAL DISK FILE
Please note that if you currently have a BASIC program in memory, save it to disk
before entering the following command. See
Save a Program
later in this section for
full details.
Type a simple command in BASIC to see a directory of the inserted disk’s contents.
LOAD "$",8
The number 8 is the standard device ID for the virtual disk drive used on THEC64.
Now type the following command to see what is stored on the disk. Only one drive is
available to THEC64.
LIST
This command shows how much space (noted as ‘blocks’, with four blocks equaling
one kilobyte (1kB)) each item uses, and how much space remains free on the disk.
72
To Next Page
Loading...
