RetroSound Model Two - Radio and USB Operation Guide

Model Two Owner’s Manual
Copyright 2014 © Retro Manufacturing, LLC Page 17
Operaon Table
Funcon # Radio Mode USB Mode
Power
On/O
1 Press the le front knob to turn the unit on. Look for
RETROSOUND on power up.
Press and hold the le front knob for 3 seconds to turn the
unit o. The LCD display will show GOODBYE for your conr-
maon.
Volume 1 Turn the le front knob to adjust the volume aenuaon
between 0 - 46 (Min/Max). 17 is the default turn-on volume
level.
Audio
Adjust
1 Press the le front knob to acvate the SEL (Select) func-
on. Press repeatedly to cycle through the DSP (Digital Signal
Processing) EQ, Bass, Mid, Treble, Balance, Fader, XBAS,
Subwoofer and Subwoofer specic adjustments (when SUB
ON is selected). Turn the le front knob to select a value.
See “Adjusng Sound Properes” on page 22 for detailed
instrucons.
Mode 2 Turn the le rear knob clockwise to select from an avail-
able listening source: RADIO, USB-1, USB-2, AUX-1, AUX-2,
BT AUDIO. Two sets of AUX inputs are located at the rear
of the radio. To ulize these inputs, AUX cables must be
routed to an accessible area during installaon. See “Wiring
Instrucons” on page 15.
NOTE: The USB opon will not appear unless media is
plugged into the USB connector.
Clock On 2 Turn the le rear knob
counter-clockwise to acvate
the clock on-screen feature.
Turn the le rear knob
counter-clockwise to toggle
and view arst, album, tle
informaon, clock.
View
Song
Info/
Clock
Preset 1
Recall/
Store
3 Press to select the #1 radio
preset.
Press and hold to store
preset 1 into memory.
Press to play/pause le play-
back.
Play/
Pause