Revitive Medic 2837AB - Page 12

22 23
h Press the power button on the device or on the remote
control to turn Revitive on.
You will hear a beep and the display lights will light up.
The time will read 30 minutes, the Intensity will
read 00 and the EMS symbol will be displayed.
i Revitive Body Pads will automatically provide
stimulation in EMS mode.
If you wish to use Revitive Body Pads in TENS Mode
press the TENS button on the remote control.
You will then see the TENS symbol on the display.
See page 24 for further instructions on how to switch
between EMS and TENS mode.
j Press the (+) Intensity Control one time to
start stimulation.
You can use the buttons on the control panel or remote
control.
Press the (+) button to increase the level.
Press the (–) button to decrease the level.
It is normal to feel tingling or varying sensations in
the muscles you are treating.
Please note that the intensity required may vary from
day to day.
Instructions for use
k The Time display will start to count down in minutes
as Revitive cycles through its program.
When Revitive times out, you will hear three beeps,
and the device will switch itself o automatically.
l Ensuring that the device is switched o, gently peel the
Body Pads from the skin.
Do not pull the Body Pads o the skin using the
Electrode cords as this may damage the cords.
m Replace the Body Pads onto their plastic liner aer use.
n Unplug the Electrode cord from the socket on Revitive.
If you feel pain or discomfort:
• Lower the intensity of the Body Pads using the (–) Intensity Control on
the device or remote control.
• You can also choose to stop therapy before the end of the 30 minute session
to avoid skin irritation and/or muscle fatigue. You can do this by pressing the
power button on the device or on the remote control.
EN
5839_IFU04_18244309.indd 22-23
5839_IFU04_18244309.indd 22-23
06/10/2021 16:44
06/10/2021 16:44