Revopoint 3D Technologies MINI - System Setup and Software; System Requirements; Software Installation; Indicator Legend

MINI 3D Scanner Quick Start Guide
COPYRIGHT ©2022 REVOPOINT 3D ALL RIGHTS RESERVED 4
System Requirements
USB mode or Wi-Fi Mode Support
Windows
Android
iOS/iPad
Mac
USB Mode
YES
YES
NO
YES
Wi-Fi Mode
YES
YES
YES
YES
Software Installation
Three softwares are provided: Revo Scan, Revo Studio and Revo Calibration. The Revo Scan is a scan software that assists
in scanning objects and obtaining 3D models; the Revo Studio is a post-process software for editing scanned 3D models; the
Revo Calibration Software uses to adjust parameters of the scanner to ensure good results.
Download the software above at official website
：
revopoint3d.com/download/
Indicator Legend
󱛻󱛼󱛽 Do not look at the front light of the projector closely for a long time! Refer to Standards for Class 1 Lasers for details.
PC: Connect to MINI 3D Scanner
Both Mac and Windows PC can be connected to MINI 3D scanner via USB cable and Wi-Fi. In the following chapter, we
are going to introduce the USB mode and Wi-Fi mode connections: for USB mode, we will take the Windows device
connection as the example, and for the Wi-Fi mode, take the Mac device connection as the example.
Windows: Win 10/Win 11
（
64 bit
）
Memory：≥ 8G
*The Windows 7 is out of support.
Android
：
≥Android 9.0
RAM：≥ 6GB
* HarmonyOS is supported.
Mac with Intel × 86 chip: Mac OS 10.15 and models after；
Mac with Apple M1 chip: MacOS 11.0 and models after；
Memory: ≥ 8G
iPhone: iPhone 8 Plus or models after;
iPad: 6
th
generation iPad and models after;
System Version: ≥ iOS 13.0;
Green:
Working
Projector in blue:
Normal