POP 3 Quick Start Guide
©2023 REVOPOINT 3D ALL RIGHTS RESERVED 15
LED Indicators
Updating the Firmware
A pop-up will notify you when you connect your POP 3 to Revo Scan if
a firmware update is available. If you want to update your firmware,
follow the install wizard’s prompts and ensure your POP 3 has a stable
power supply.
Scanner Calibration
Your POP 3 3D Scanner was calibrated in the factory and only needs to
be recalibrated after a year of use or if the scanned results do not
match the specified accuracy.
Maintenance Instructions
1. Small parts, such as markers, are dangerous if swallowed. Keep all
components out of reach of children and animals to avoid serious
injury to them.
2. Store the scanner and all accessories in a cool, dry place away from
direct sunlight.
3. Do not allow the scanner to come into contact with or become
To Next Page
Loading...
