POP 3 Quick Start Guide
16 ©2023 REVOPOINT 3D ALL RIGHTS RESERVED
immersed in water or other liquids. Wipe it with a soft, absorbent cloth
if it gets wet. Operating a scanner that has gotten wet may cause
permanent component damage.
4. Keep the cameras and projector (the two IR cameras, one RGB
camera and a projector) clean. Use 95% isopropyl alcohol and a soft
cloth to clean them.
5. Handle the scanner with care to avoid hitting the cameras.
6. The operating temperature POP 3 of this product is 0°C to 40°C (32°F
to 104°F).
7. Do not disassemble the scanner. If there are any problems or
questions, contact the Revopoint customer service team at
customer@revopoint3d.com.
Customer Service
If you need any assistance with your scanner, please don’t hesitate to
contact us at customer@revopoint3d.com or drop us a line at +1 (888)
807-3339 or chat with one of our customer service agents online on our
website at www.revopoint3d.com. Click the speech bubble on the
bottom right corner of the screen.
To Next Page
Loading...
