RANGE Quick Start Guide
18 ©2023 REVOPOINT 3D ALL RIGHTS RESERVED
Unfortunately, you’ll need to redo the scan, but be careful and ensure
you only scan an area once rather than multiple times. Basically, the
smaller the number of frames, the better the scan quality. Scanning the
same spot twice will only lower the detail.
6. What to do if you keep running out of memory when scanning?
The object you’re scanning is too large for your computer or
smartphone’s amount of RAM. If this happens, pause the scan, fuse the
model, and start a new scan from where you had to pause your
previous scan. These separate scans can be merged together in Revo
Studio to make a whole model once you’ve finished scanning the object.
7. How do I reset the scanner?
Connect your RANGE to a power source, then press the RANGE’s
Start/Pause scan button ten times to reset the RANGE.
Customer Service
If you need any assistance with your scanner, please don’t hesitate to
contact us at customer@revopoint3d.com or drop us a line at +1 (888)
807-3339 or chat with one of our customer service agents online on our
website www.revopoint3d.com. click the speech bubble on the bottom
right corner of the screen.
To Next Page
Loading...
