5
Step 1: Install the Dash Camera
Adhesive Mount: Place the 3M tape on the mount and properly orient the mount
square to the roof and hood line of the vehicle. Firmly press the mount onto the
windshield. Wait at least 20 minutes before mounting the camera. Orient the mount
as shown on the illustration below.
Suction Cup Mount: Remove the protective plastic from the suction cup, clean the
mounting area of the windshield with rubbing alcohol, and wipe dry with a lint free
cloth. Now, clean the back of the suction cup with rubbing alcohol and wipe dry with
a lint free cloth. Next, apply moisture to the suction cup to create a better seal and
mount the suction cup to the windshield as shown below and wait approximately 30
minutes for it to dry. Once dry, attach the device by fitting the tab on the top of the
mount into the slot on the top of the device.
Installation
Orient the mount as shown
To Next Page
Loading...
