a. The rearview camera can be mounted directly above the rear window inside the car.
b. The rearview camera can be mounted directly above the car’s license plate.
For the rearview camera, there are two wiring options as shown in the above figure.
The first part of both options is characterized with concealed wire routing against the
edges of the door(s).
We recommend that you install all components beforehand according to the above
drawing and test the system by using the on-board charger power supply. Make sure
the device is good condition prior to installation. Please, contact our service center in
case of any questions.
11
Connect the dash cam to the car charger after installation. Starting the car engine
will start the device.
Due to unstable voltages caused by starting the car engine, a voltage fluctuation in
some vehicles may be especially obvious. If a flashing screen or some other
unforeseeable operating problem occurs when you start the engine, it is
recommended to unplug the device from the charger before starting the engine, and
then reconnect it after the engine is running.
Note:
III. Turn on the Dash Cam
To Next Page
Loading...
