22
Note:
Option 2: Motion Detection
If you do not use the parking mode function, please change the Gravity
Sensing sensitivity to low. Otherwise, the video will easily be locked and
the video cannot be deleted by the loop recording function. This will
cause the memory card to be full of locked videos and cause the
recorder to fail to work normally.
Please DO NOT ENABLE the Parking Monitor function in the settings of the
dash cam WITHOUT connecting a smart hardwire kit. They may cause a
malfunction.
To use this feature, you need to connect it with a Rexing Intelligent
Hardwire Kit (sold separately). Make sure that the Parking Mode is turned
o on your dash cam, otherwise it may cause a malfunction.
Once the sensor has detected MOTIONS. The intelligent hardwire kit will
power up the dash cam automatically and start recording until the
MOTION is cleared.
Please go to
https://www.rexingusa.com/hwk-install/
to watch a video tutorial about the installation or scan the QR code
To Next Page
Loading...
