Note:
If you do not use the parking mode function, please change
the Gravity Sensing sensitivity to low. Otherwise, the video will
easily be locked and the video cannot be deleted by the loop
recording function. This will cause the memory card to be full
of locked videos and cause the recorder to fail to work
normally.
Please DO NOT ENABLE the Parking Monitor function in
the settings of the dash cam WITHOUT connecting a
smart hardwire kit. They may cause a malfunction.
Option 2: Motion Detection
To use this feature, you need to connect it with a Rexing
Intelligent Hardwire Kit (sold separately). Make sure that the
Parking Mode is turned off on your dash cam. Make sure
that the Parking Mode is turned off on your dash cam,
otherwise it may cause a malfunction.
Once the sensor has detected MOTIONS. The intelligent
hardwire kit will power up the dash cam automatically and
start recording until the MOTION is cleared.
Please go to
https://www.rexingusa.com/hwk-install/
to watch a video tutorial about the installation or scan the QR
code below.
To Next Page
Loading...
