Note:
If you do not use the parking mode function, please change the Gravity Sensing
sensitivity to low. Otherwise, the video will easily be locked and the video cannot
be deleted by the loop recording function. This will cause the memory card to be
full of locked videos and cause the recorder to fail to work normally.
Please DO NOT ENABLE the Parking Monitor function in the settings of the
dash cam WITHOUT connecting a smart hardwire kit. They may cause a
malfunction.
Option 2: Motion Detection
To use this feature, you need to connect it with a Rexing Intelligent Hardwire Kit
(sold separately). Make sure that the Parking Mode is turned off on your dash
cam, otherwise it may cause a malfunction.
Once the sensor has detected MOTIONS. The intelligent hardwire kit will power
up the dash cam automatically and start recording until the MOTION is cleared.
Please go to
https://www.rexingusa.com/hwk-install/
to watch a video tutorial about the installation or scan the QR code below.
17
To Next Page
Loading...
