REXON RM-03N - Burst Tone Frequency Selection; DTMF ANI On;Off Setting; Channel Mode Selection

PAGE 19
3. The LCD will show working voltage.
• Burst Tone Selection
Burst tone is an alternative means of accessing the repeater, in ad-
dition to CTS or DCS tone.
1. Hold button for 2 seconds to get into general setting menu.
2. Press button repeatedly or press Up/Down key on extended
microphone till LCD displays “TBST”
3. Rotate power knob to set burst tone at either 1750Hz, 2100Hz,
1000Hz, or 1450Hz.
 Default: 1750Hz
• DTMF ANI On/Off
Alpha Numeric Identication function is available by DTMF or 5Tone
signaling. Enable this function, the radio will display the caller’s ID
number when receiving a DTMF ANI calling
1. Hold button for 2 seconds to get into general setting menu.
2. Press button repeatedly or press Up/Down key on extended
microphone till LCD displays “DTMF ANI”
3. Rotate power knob to switch ON/OFF.
4. OFF: DTMF ANI is disable; ON: DTMF ANI is enabled.
 Default: OFF
 Notice: DTMF or 5 tone ANI must be set through PC pro-
grammer.
• Channel Mode Setup
There are 3 different Channel modes: Channel+frequency mode,
Channel+name tag mode, & Channel mode.
1. Hold button for 2 seconds to get into general setting menu.
2. Press button repeatedly or press Up/Down key on extended