PAGE 23
won’t be open until receiving a correspondent 2-Tone signal. To
transmit the pre-stored 2-Tone signaling, hold “PTT” then press
UP.
6. “5Tone”: the channel will be mute by a 5-Tone signal. The speaker
won’t be open until receiving a correspondent 5-Tone signal. To
transmit the pre-stored 5-Tone signaling, hold “PTT” then press
UP.
7. “OFF”: DTMF, 2Tone, or 5Tone signaling decoder is cancelled and
this channel will not be mute.
• Sending 2-Tone Call
1. Press button to get into channel menu.
2. Press button repeatedly or press Up/Down key on extend-
ed microphone till LCD shows “2TONE CALLXX” , XX means the
group in the list.
3. Rotate power knob to select the 2-Tone group you want to send.
Press PTT to transmit the selected 2Tone group call.
There are up to 32 groups of 2-Tone Call to be set with name
alias through PC programmer.
• Sending 5-Tone Call
1. Press button to get into channel menu.
2. Press button repeatedly or press Up/Down key on extend-
ed microphone till LCD shows “5TONE CALLXX” , XX means the
group in the list.
3. Rotate power knob to select the 5-Tone group you want to send.
Press PTT to transmit the selected 5-Tone group call.
There are up to 100 groups of 5-Tone Call to be set with
name alias through PC programmer.
To Next Page
Loading...
