2-2 Safety Instructions for Electric Drives and Controls Rexroth IndraDrive FCS01.1
DOK-INDRV*--FCS01*****-IB01_EN-P
• The devices have been designed for installation in industrial
machinery.
• The ambient conditions given in the product documentation must be
observed.
• Only use safety-relevant applications that are clearly and explicitly
approved in the Project Planning Manual. If this is not the case, they
are excluded.
Safety-relevant are all such applications which can cause danger to
persons and material damage.
• The information given in the documentation of the product with regard
to the use of the delivered components contains only examples of
applications and suggestions.
The machine and installation manufacturer must
• make sure that the delivered components are suited for his
individual application and check the information given in this
documentation with regard to the use of the components,
• make sure that his application complies with the applicable safety
regulations and standards and carry out the required measures,
modifications and complements.
• Startup of the delivered components is only permitted once it is sure
that the machine or installation in which they are installed complies
with the national regulations, safety specifications and standards of the
application.
• Operation is only permitted if the national EMC regulations for the
application are met.
• The instructions for installation in accordance with EMC requirements
can be found in the documentation "EMC in Drive and Control
Systems".
• The machine or installation manufacturer is responsible for
compliance with the limiting values as prescribed in the national
regulations.
Technical data, connections and operational conditions are specified in
the product documentation and must be followed at all times.
To Next Page
Loading...
Need help?
General
