REXROTH IndraDrive Fc FCS01 User Manual

15-24 Control Communication - Field Busses and Protocols Rexroth IndraDrive FCS01.1
DOK-INDRV*--FCS01*****-IB01_EN-P
PROFIDRIVE Standard Parameter
The following parameters defined by the PROFIBUS profile are realized in
the PROFIBUS module:
PNU Explanation
918 Node address
927 Control sovereignty PIDV (always 1, i.e. PROFIBUS interface)
947 Error number:
The current error number is stored in this parameter.
965 Profile number (3.0)
967 Control word
968 Status word
970 Load data record
When the parameter is set to the value 1, a factory setting is made
and all change bits are set to 0.
971 Integration into the non-volatile memory
(is always done automatically)
Fig. 15-33: PROFIBUS module
These parameter numbers are not mapped.
Consistent Data Transmission
Usually, a PLC can only consistently transmit double words by I/O
memory access. With longer data formats (PIDV channel generally / PCD
with PPO2 or PPO4), system functions must be used (e.g. SFC14/15).

REXROTH IndraDrive Fc FCS01 Specifications

General

Category	Controller
Control Voltage	24V DC
Communication Interface	SERCOS III, Ethernet/IP, PROFINET, EtherCAT, PROFIBUS
Cooling Method	Natural convection
Power section	Integrated
Protection class	IP20
Type	FCS01
Current Rating	Dependent on model
Dimensions	Dependent on model
Input voltage range	3 x AC 380V-480V
Output current	Dependent on model
Ambient temperature range	0°C to +45°C
Storage temperature range	-25 to +70 °C
Relative humidity	5% to 85%, non-condensing
Weight	Varies depending on model (refer to datasheet)