REYHEE CRUISER - How to Use the Rear Lever

How to use the rear lever
Location of the rear lever
“D” = Drive mode
“N” = Neutral (freewheel) mode
1)
2)
3)
Shift the rear lever downward to engage Drive mode.
Drive mode must be used whenever the user is seated in the Cruiser and operating it
using the console and dual throttle control levers.
•
•
Drive mode ensures that the Cruiser will be able to automatically brake whenever the
user releases the throttle control levers.
•
Shift the rear lever upward to engage Neutral mode.
Neutral mode must be used whenever the Cruiser is being manually pushed or
transported.
•
•
Neutral mode ensures that the Cruiser’s wheels will be able to spin freely without the
use of the motor or dual throttle control levers.
•
The rear lever is red and located on the right side of the Cruiser body, behind the seat.
DO NOT attempt to operate the rear lever while seated in the Cruiser, as
this may cause strain or injury. Ensure that you move the rear lever to the
desired mode PRIOR to sitting in the Cruiser, or – if already seated – seek
assistance to operate the lever.
•
•
DO NOT use excessive force or pressure on (e.g. standing on top of) the
rear lever, as this may cause irreversible damage to the product.
•
Warnings:
Ensure that the rear lever is in NEUTRAL mode before the Cruiser is disassembled and
transported.
•
While the rear lever is in neutral mode, be aware that the Cruiser does NOT
automatically brake, so it must be operated at the highest level of caution.
•
Warnings:
How to Operate Your Cruiser (Cont.)
31