REYHEE CRUISER - Getting in and Sitting in the Cruiser

Getting in and sitting in the Cruiser
Option #1: Getting into the Cruiser seat from the deck
First ensure that the Cruiser is:
2)
1)
Battery pack is fully charged and sitting in the battery terminal.
Power is OFF, and rear lever is in DRIVE mode.
b)
c)
Charger is disconnected and safely placed out of the way.d)
Fully and correctly assembled.a)
NO children or pets are on the seat.e)
Orient yourself until your back is facing the seat.
Gradually sit down on the seat, using the (lowered) armrests as support if needed.
b)
c)
Ensure stable footing before gradually getting onto the deck.a)
The handlebar can be gripped for support during this step, but DO NOT lean
your full weight against it, to prevent potential injury or product damage.
Option #2: Getting into the Cruiser seat after swiveling the seat to the side2)
Firmly grip the handle of the lever with one hand.
Pull the lever FORWARD while simultaneously rotating the seat with the other hand.
b)
c)
It is strongly recommended that the seat be swiveled until it is perpendicular to the
frame, for safety, before you are seated.
d)
Reach beneath the seat to grip the handle of the swivel lever with one hand.g)
Pull the lever FORWARD while simultaneously rotating the seat with the weight of your
body until the seat is facing forward (towards the tiller).
h)
Locate the seat swivel lever (beneath the seat).a)
Ensure steady footing and orient yourself until your back is facing the seat.e)
Gradually sit down on the seat, using the (lowered) armrests as support if needed.f)
If needed, use additional pressure to rotate the seat by bracing your feet against the
ground, until your feet are both at and safely on the deck.
How to Operate Your Cruiser (Cont.)
33