Use a clean cloth or any other clean absorbent material to thoroughly
soak up as much liquid as possible. Then allow the seat / seat-back to
dry completely before resuming use of the Cruiser.
On the seat or seat-back:
•
Parts replaceable by the user
Check www.reyhee.com or contact customer support to access the current list of
parts replaceable by the user (e.g. battery pack).
In case of any liquid spill, power OFF immediately and follow the instructions
below:
a)
b)
Before each use of the Cruiser, check that all parts are CLEAR of debris, dirt,
dust, and anything else that may cause obstruction or potential deterioration
over time. Use a soft, dry cloth if needed.
a)
4)
Cosmetic maintenance:3)
Ensure the power is OFF and exercise caution (e.g. wear protective
gloves) when removing any debris, dirt, dust, etc.
DO NOT USE any cleaning solvents/solutions/liquids or spraying devices
(e.g. a hose) to clean any part of the Cruiser, as this may result in
irreversible product damage and will VOID your warranty.
Use a clean cloth or any other clean absorbent material to thoroughly
dry the frame before resuming use of the Cruiser.
On the frame:
•
Use a clean cloth or any other clean absorbent material to thoroughly
soak up as much liquid as possible.
On any electronic part or component (including the console, battery pack,
its charging port, and battery terminal):
•
DO NOT ATTEMPT to power on and use the Cruiser, as this may
result in electric shock and/or exacerbate any damage that may already
be caused by the liquid.
•
Contact customer support to locate the nearest authorized service dealer
for inspection.
•
Any replaceable parts may be subject to additional cost, depending on the
applicable warranty terms and conditions.
The list and availability of said parts are subject to change at any time
without prior notice.
Maintenance (Cont.)
46
To Next Page
Loading...