To Next PageTo Next PageWhat to do if my Rheem Furnace pressure switch is stuck open?
If the pressure switch on your Rheem Furnace is stuck open when it should be closed, inspect for a blocked vent, excessive vent length or elbows, or a blocked heat exchanger.
What to do if my Rheem R95P has failed ignition?
If your Rheem Furnace experiences failed ignition, check the wires, continuity, and connection between the IFC and the gas valve.
What to do if my Rheem R95P has unexpected flame?
If your Rheem Furnace is producing an unexpected flame, check for intermittent Pressure Switch operation.
What to do if my Rheem Furnace has low flame sense?
If your Rheem Furnace has a low flame sense, check the flame sense rod and clean it if necessary.
What to do if my Rheem Furnace has flame lost?
If the flame is lost in your Rheem Furnace, check the wires and connections between the IDM and IFC.
What to do if my Rheem R95P Furnace blower is unable to run?
If the blower in your Rheem Furnace is unable to run, check the wires and connections, and verify the continuity between the IFC and IBM.
What to do if my Rheem Furnace has main limit open?
If the main limit is open on your Rheem Furnace, check the switches and hoses for water or moisture.
How to fix twinning fault in Rheem Furnace?
For twinned Rheem Furnace units experiencing a twinning fault, verify that both IFCs are set to 'TWIN' and that the wires are connected between the 'TWIN' terminals.
What to do if my Rheem R95P Furnace has line and neutral reversed?
If the line and neutral are reversed in your Rheem Furnace, check for proper polarity between L1 & neutral.
General| Model | R95P |
|---|---|
| Type | Gas Furnace |
| Efficiency Rating | High Efficiency |
| AFUE | 95% |
| Vent Type | Direct Vent |
| Blower Motor | ECM |
| Heat Exchanger Material | Stainless Steel |
| Heating Capacity | 40, 000-120, 000 BTU/h |
| Fuel Type | Natural Gas |
| Stages | Two-Stage |
| Warranty | Limited Lifetime Heat Exchanger, 10-Year Parts |
| Blower Type | Variable Speed ECM |
