Need help?Do you have a question about the Rheem RKKL Series and is the answer not in the manual?
General| Refrigerant | R410A |
|---|---|
| Series | RKKL Series |
| Type | Split System Air Conditioner |
| Power Supply | 208-230V/60Hz/1Ph |
| Dimensions (Outdoor Unit) | Varies by model |
| Weight (Outdoor Unit) | Varies by model |
| Indoor Unit Type | Wall-mounted |
Provides critical warnings regarding unit operation, electrical hazards, gas leaks, and potential damage or injury.
Details general information about the rooftop units, including heating input and cooling capacities.
Lists the main components included in the typical rooftop unit.
Covers specifications, application, pressure, and combustibility of R-410A refrigerant.
Presents detailed cabinet dimensions and access locations for the unit.
Outlines general installation standards, codes, and recommended publications.
Discusses factors for selecting unit location, including environmental conditions and potential corrosion.
Provides guidance for installing units outdoors, including slab installation and clearance requirements.
Details the procedure for attaching the exhaust and combustion air inlet hoods.
Explains how to install or convert cover panels for downflow applications.
Provides instructions for filter replacement, including recommended suppliers.
Specifies minimum required clearances for proper unit performance and serviceability.
Addresses considerations for rooftop installation, including structural support and rigging.
Guidance on fabricating ductwork in accordance with local codes and industry standards.
Details requirements for return air ductwork to prevent combustion products from entering the living space.
Instructions for connecting the gas supply piping in accordance with codes and standards.
Procedure and warnings for converting the unit from natural gas to LP gas.
Guidance on checking and adjusting furnace input, including pressure settings and altitude derating.
Instructions for installing the condensate drain, including trap requirements and piping.
Details power supply requirements, including voltage, wire size, and circuit protection.
Instructions for wiring the unit, including connections to external devices.
Information on the unit's internal wiring diagram and replacement wire specifications.
Guidance on thermostat compatibility and low voltage wiring.
Describes the sequence of operations for the furnace's two-stage ignition control.
Details the operating sequences for first and second stage heat calls.
Provides step-by-step instructions for starting and operating the furnace.
Recommendations for the customer regarding unit operation and maintenance.
Procedures for annual inspection and cleaning of the furnace section components.
Guidance on inspecting and cleaning the evaporator coil and condenser section.
Information on how to obtain replacement parts for the unit.
Provides a chart to diagnose and resolve cooling system issues.
References to complete wiring diagrams for the unit and its power sources.
Guides on proper refrigerant charging procedures using system charge charts.
To Next Page