38
Re-assembly
1. Reconnect fan motor wires per the wiring diagram attached to the back of the cover.
2. Close the filter control and replace the blower/evaporator coil access panels.
3. Replace the control box cover.
4. Restore electrical power to the unit and check for proper operation, especially the
condenser fan motor.
REPLACEMENT PARTS
Contact your local distributor for a complete parts list.
TROUBLESHOOTING
Refer to Figures 19 and 20 for determining cause of unit problems.
WIRING DIAGRAMS
Figures 21 through 28 are complete wiring diagrams for the unit and its power sources.
Also located on back of compressor access panel.
CHARGING
See Figures 29 through 40 for proper charging information.
To Next Page
Loading...
