36
G
B
NYLON RACK MODULE 4
with zinc plated angle Iron, In 1mt. bars. Ideal for gates up to 1,000 kg / 2,200 lbs weight.
1 m / 3,28” code ACS9000
10 m / 32,8” (1 m / 3,28” x 10) code ACS9001
ACCESSORIES - For the connections and the technical data of the optional equipments follow the relevant handbooks.
PROBE
The probe detects the motor temperature to operate the heating system under low
temperature conditions, up to -30°C (connect to connector J6). code ACG4665
SPARK
In order to make the systems mentioned above give the best performances, you need to
install an antenna tuned on the frequency of the radio receiver installed.
N.B. Pay attention to not let the central wire of the cable to came Into contact with
the external copper sheath, since this would prevent the antenna from working.
Install the antenna vertically and in such a way the remote control can reach it.
SPARK BLINKER WITH IN-BUILT INTERMITTENT CARD code ACG7059
LATERAL SUPPORT code ACG7042
SPARK ANTENNA 433 code ACG5452
RACK MODULE 4
with zinc plated angle Iron, in 2 m bars.
Ideal for gates up to 1,000 kg / 2,200 lbs weight. code ACS9050
PLATE TO BE CEMENTED
code ACG8107
BLOCK
BLOCK KEY SELECTOR FOR WALL-INSTALLATION code ACG1053
BLOCK KEY SELECTOR TO BUILA-IN code ACG1048
FIT SYNCRO
FIT SYNCRO PHOTOCELLS for the wall-installation code ACG8026
The range you can set is 10-20 m, 30÷60ft.
You can fit many couples close together thanks to the synchronising circuit.
Add the SYNCRO TRANSMITTER code ACG8028
for more than 2 photocells couples (up to 4).
COUPLE OF BUILT-IN BOXES FOR THE FIT SYNCRO code ACG8051
PAIR OF COLUMNS FOR FIT SYNCRO H = 0,5 m code ACG8057
RADIO TRANSMITTER SUN
SUN 2CH cod. ACG6052 SUN 4CH cod. ACG6054
SUN CLONE 2CH cod. ACG6056 SUN CLONE 4CH cod. ACG6058
To Next Page
Loading...
