PostScript 3 - Setting Up for Printing
4
1
❖
❖❖
❖ [Printer features]
The functions that can be used in this machine are displayed.
It is possible to make changes using [Change setting for]. Select the functions
you want to use from [Printer features], and then from the drop down menu in
the [Change setting for] box, select the settings.
❖
❖❖
❖ Adjust Image Brightness
The brightness of the whole printed image can be adjusted to one of seven
levels.
Note
❒ The brightness of the color of characters does not change.
❖
❖❖
❖ “Printer-Side Operation”
It is possible to perform a few things using both the machine's display pan-
el and the printer driver installed in the computer. When “Printer-Side Op-
eration” is set to “On”, the following items are enabled on the display
panel.
• Sort
• Clear Modes
• Speed Select
• Auto-Print after Master Making
• Job Separator
• Skip Feed
• Eco. Mode
• Number of print sets
Note
❒ “Auto-Print after Master Making” is displayed on the machine's dis-
play panel as “Auto Cycle”.
❖
❖❖
❖ “Clear Modes”
When set to “On”, the machine settings return to their defaults before Mas-
ter Making.
❖
❖❖
❖ “Auto-Print after Master Making”
When set to “On”, printing starts automatically immediately after Master
Making.
❖
❖❖
❖ “Eco. Mode”
When set to “On”, the amount of ink consumption is reduced.
❖
❖❖
❖ “Speed Select”
You can select the printing speed.
❖
❖❖
❖ “Skip Feed”
• Use to make the interval between paper feeds longer, allowing the ink
to dry.
• Use to print paper longer than the standard size.
To Next Page
Loading...
