Troubleshooting
60
5
Processing Data is printed.
Wait until the job is finished.
Ready for Master Making/
printing (Online)
The Master Making or print data is not in the spool.
This is not an error. The message will change when printing
starts from the computer.
Ready for Master Making/
printing
Resetting Job... The data spooled is dumped.
Wait until the job is finished.
ROM Error. The ROM inside the machine is abnormal.
Consult your sales or service representative.
Selected paper size is una-
vailable, press [MakeMstr] to
continue as is, or set ### pa-
per then press [OK].
The specified paper size has not been set.
Set an appropriate amount of paper, and then press [OK].
Note
❒ “###” in the message represents a paper size.
Set ### paper in Tray ???,
then press [OK].
No paper in the Paper Feed Tray.
After setting ### paper in the Paper Feed Tray, press [OK] to
continue.
Note
❒ “###” in the message represents a paper size.
❒ “???” in the message represents the Paper Feed Tray.
Set ### size paper in the Ex-
ternal Tray, then press [OK].
[Make Mstr] has been pressed when the specified paper size has
not been set.
Set an appropriate amount of paper in the Paper Feed Tray and
press [OK]. Inconsistencies in the size of paper from the Paper
Feed Tray will be ignored and printing will be performed. Press
[Job Reset] to stop printing.
Note
❒ “###” in the message represents a paper size.
❒ The External Tray and the Paper Feed Tray are the same.
Set Tray ??? correctly, then
press [OK].
The Paper Feed Tray is not set correctly.
After correctly setting the Paper Feed Tray, press [OK].
Note
❒ “???” in the message represents the Paper Feed Tray.
Waiting... Waiting for data from the computer.
Wait until the job is finished.
Messages/Second messages Descriptions and Solutions
To Next Page
Loading...
