Using the Control Panel
68
6
8 I/O Timeout Sets the time to enable the interface after data stops being re-
ceived. When the time set here is exceeded, it will be possible to
receive data from the other interface.
Important
❒ If the set time is too short, a time out might occur while one
data is being received. As a result, data from another interface
might cut in and be printed, or the emulation retrieval from
half of the data may be activated, and be replaced with a dif-
ferent emulation.
Note
❒ Default: 30 sec.
9 I/O Buffer Sets the capacity of the reception buffer.
Note
❒ Default: 512KB
10 Menu Reset You can reset the factory settings. However, the “IP Address”,
“Network”, and the “Ethernet Speed” settings do not change.
No. Mode Description
To Next Page
Loading...
