Replacing Photo Conductor Unit (PCU)
97
3
G Put the photo conductor unit re-
moved in step E into the plastic
bag emptied in step F, keeping
the unit at the same angle as when
it was installed. Then, zip the
plastic bag.
Note
❒
Do not tilt the used PCU after
Removing it from the machine.
If you do, toner might fall.
H Remove the two red sheets from
the photo conductor unit in the
order shown in the illustration.
Important
❒
Remove the photo conductor
unit keeping the unit parallel to
the ground as shown in the il-
lustration. Otherwise, the toner
in the unit might scatter.
❒
Do not touch the inside of the
unit or the green parts, after the
black protection sheet is re-
moved.
I Align the new photo conductor
unit onto the rail of the machine.
Slide the unit all the way into the
machine.
J Push the unit into the machine
until it clicks into place.
K Remove the red sheet from the
photo conductor unit and remove
the two pieces of tape.
To Next Page
Loading...
