x
Clearing Misfeeds
99
3
x
Clearing Misfeeds
CAUTION:
Important
❒
When clearing misfeeds, do not turn off the power switch. If you do, your
copy settings are cleared.
❒
To prevent misfeeds, do not leave any torn scraps of paper within the ma-
chine.
❒
If paper misfeeds occur repeatedly, contact your service representative.
Note
❒
More than one misfed areas may be indicated. In this case, check every appli-
cable area. Refer to the following charts: A, B, C, D, R, P, Y, Z
❒
You can find a sticker explaining how to remove misfed paper inside of the
front cover, upper side of the finisher.
❒
When the machine instructs you to reset originals, reset your originals to the
feeding position. The display will indicate the number of originals you
should return.
•
When removing misfed paper, do not touch the fusing section be-
cause it could be very hot.
To Next Page
Loading...
