User Tools (Copy Features)
120
4
2. Adjust Image
1
/
2
2. Counter Reset You can check the number of copies made under each user
code. You can also reset each user code's counter to 0.
Note
❒
If more than one user code is registered, you can view all
the counters using the [
↑
Prev.
] or [
↓
Next
] key.
3. Clear Code/Counter You can delete all user codes or reset all counters to 0.
4. Prog. User Code You can register user codes.
Note
❒
Up to 50 user codes (8 digits or less) can be registered.
5. Chg/Del User Code You can change or delete user codes.
Note
❒
The number of copies made under the old code is added
to that made under the new user code.
❒
The number of copies made under the deleted code is
also deleted.
6. Counter List Print You can print a list of counters shown by user code.
Limitation
❒
If A4, 8
1
/
2
"
×
11" or larger paper is not set in the paper
trays, this list cannot be printed.
Note
❒
To stop the printing, press the [
Cancel
] key.
Menu Description
01. Border Erase Width The default width of erased margins in Border Erase mode
can be changed as follows:
• Metric version: 3 – 50mm in 1mm steps
• Inch version: 0.1 – 2.0" in 0.1" steps
Note
❒
Default:
• Metric version:
10mm
• Inch version:
0.4"
Menu Description
To Next Page
Loading...
