Fax Features
76
4
❖ Set User Function Key 1-3
Program frequently used functions in the User Function Keys.
The User Function keys can be programmed with the following items:
• Print Journal
• TX File Status (Transmission File Status)
• RX File Status (Reception File Status)
• 2 Sided TX (Two-sided transmission)
•Print Fax Header
•Forwarding
• Switch Reception Mode
• Start Manual Reception
• Sender Settings
•Transmission Stamp
•E-mail Options
• Print TX Status Report (Print Transmission Status Report)
• Manual E-mail Reception
• Select Line/SMTP
• SUB/SEP Code
•Specify Dest. Reg. No.
• *Not programmed
Up to three functions can be programmed to User Function keys.
The default setting for User Function Key 1 is Start Manual Reception.
The default setting for User Function Key 2 is Switch Reception Mode.
The default setting for User Function Key 3 is Transmission Stamp.
A Select [Fax Features] using {U} or {T}, and then press the {OK} key.
B Select [General Settings/Adjust] using {U} or {T} , and then press the { OK}
key.
C Select [Set User Function Key] using {U} or {T}, and then press the { OK} key.
D Press the User Function key you want to program.
E Select the function you want to program in the User Function key using
{U} or {T}, and then press the { OK} key.
Reference
p.4 “Accessing User Tools”
p.87 “Registering Fax Information”
"Adjusting the Volume", Troubleshooting
"Reading the Display Panel and Using Keys", Facsimile Reference
"Sending at a Specific Time (Send Later)", Facsimile Reference
To Next Page
Loading...
